News

Home / News / Industry News / The Detail Of Replacing The Motorcycle Brake Pads

The Detail Of Replacing The Motorcycle Brake Pads

Update:09-10-2017
Summary:

Brake system plays a very important role in the motorcy […]

Brake system plays a very important role in the motorcycle, which accident you need to pay attention to the situation of motorcycle brake pads, so your brake shoe thickness of less than 2mm, you should be prepared to replace it, although Some Mo friends that brake shoes left a little bit enough. But the intense control, in fact, such a brake force has been affected.

First of all, the first step to remove the caliper, if it is a single single piston, you need to prepare a large word screwdriver, the fixed brake pads pulled out. Now basically use the bolt or shrapnel fixed brake pads. Open the brake pads, the first do not worry to lose it, to check the brake pad wear is not very uniform. Assuming that the brake pads are unevenly worn (with a thin side and thicker side), you should check if the piston is jammed because the piston movement is uneven and the brake shoe is abnormally worn. This represents the maintenance of your caliper.

After the motorcycle brake pads is removed, it is necessary to clean the parts of the caliper and remove the things that should not be seen on the caliper, such as the brake dust. Most of the knights feel the moisture in the air because the dust adsorbs water vapor, Of the oil seal, and then into the entire closed brake system inside, but in fact not always, dust and moisture and sand combination, will become a kind of gelatinous material, attached to the surface of the piston, let it slide more smoothly.

As the material of the brake pads will leave traces on the brake discs, it is necessary to remove the residues before installing the new brakes. To replace the brakes, it is necessary to remove the remaining substances. The new brakes are in good contact , Even if you put on the same model with the same brand of brake pads, you still have to remove the residue on the disc, you can use 60 or 80 of the matte paper to complete the task, first with the parking frame will be the front wheel From the sandpaper on the disc and rotate the tire a few laps, the other side is also repeated steps, not too rude to hurt the brake disc, just remove the above deposits, spray some cleaners and clean with a clean cloth to complete The brake was clean. And then you can install the motorcycle brake pads.

© 2016 Hangzhou TSF Auto Parts Co.,ltd. All Rights Reserved. Web support by :HWAQ Sitemap